This one just in... 1967 Chevrolet Chevy II. The car really has the stance and the overall look we all love. The body is really good and straight with no signs of rust. The paint, body, chrome and britework is all very nice on this one. The car was a full blown pro street car at one time and has been updated at some point. The Chevy II had a complete front stub installed from TCI, with tubular control arms and coilovers. The car drives like its on rails! The10 bolt rear axle was narrowed and coil over suspension with a 4 link setup installed. The car with a stance like this also needed really cool rollers. Billet Specialties 17 X 12's in the rear with a 315/35/17 tire and a 17x7 in the front give the car the look! The powerplant is a 355 SBC 010 casting block backed by a TH350 transmission with a 3000 stall converter. The car has an Aluminum Air Gap intake, Edelbrock carb and Electronic ingition. A billet pulley setup was used along with billet brackets and coated headers. The Nova has power rack and pinion steering and 4 wheel disc brakes also. The motor is a mild pump gas motor. On the inside the car has a new custom interior, custom stitched black material covers the whole interior as well as the trunk. The rear seat area is really cool with the custom floor console flowing into it. The interior again is fresh and all new. The car has a fuel cell and the battery are hidden in the trunk area, covered nicely but easily accessible. This one gets the attention of all everywhere it goes!  Call Scott at 615 476 1195 for more details.  Dont miss this one! DO NOT HESITATE TO CALL... THESE CARS GO FAST! Tn residents will pay all applicable tax ,tag and doc fees. All out of state buyers will pay a $124.95 doc fee and a .003% tax required by my state on all out of state sales. (about 30 bucks on 10k) TNRODS